Cisco 300 Series Cli Manual page 989

50
989
Syntax
config
show tech-support [
Parameters
•
memory—(Optional) Displays memory and processor state data.
•
config—(Optional) Displays switch configuration within the CLI commands
supported on the device.
Default Configuration
By default, this command displays the output of technical-support-related show
commands. Use keywords to specify the type of information to be displayed. If
you do not specify any parameters, the system displays all configuration and
memory data.
Command Types
Switch command.
Command Mode
User EXEC mode
User Guidelines
Caution: Avoid running multiple show tech-support commands on a switch or
multiple switches on the network segment. Doing so may cause starvation of
some time sensitive protocols, like STP.
The show tech-support command may time out if the configuration file output
takes longer to display than the configured session time out time. If this happens,
enter a set logout timeout value of 0 to disable automatic disconnection of idle
sessions or enter a longer timeout value.
The show tech-support command output is continuous, meaning that it does not
display one screen at a time. To interrupt the output, press Esc.
If the user specifies the memory keyword, the show tech-support command
displays the following output:
•
Flash info (dir if exists, or flash mapping)
•
Output of command show bootvar
•
Buffers info (like print os buff)
•
Memory info (like print os mem)
memory
| ]
OL-32830-01 Command Line Interface Reference Guide
System Management Commands