Dot1X Re-Authenticate - Cisco 300 Series Cli Manual

802. 1 X Commands
OL-32830-01 Command Line Interface Reference Guide
Examples
Example 1. This example enables user-based VLAN assignment. If the RADIUS
server authorized the supplicant, but did not provide a supplicant VLAN, the
supplicant is rejected.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)# exit
Example 2. This example enables user-based VLAN assignment. If the RADIUS
server authorized the supplicant but did not provide a supplicant VLAN, the
supplicant is accepted and the static VLAN configurations is used.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)# exit
2.17

dot1x re-authenticate

The dot1x re-authenticate Privileged EXEC mode command manually initiates
re-authentication of all 802.1X-enabled ports or the specified 802.1X-enabled
port.
Syntax
dot1x re-authenticate [
Parameters
•
interface-id —Specifies an Ethernet port.
Default Configuration
If no port is specified, command is applied to all ports.
Command Mode
Privileged EXEC mode
interface gi11
dot1x radius-attributes vlan
interface gi11
dot1x radius-attributes static
interface-id ]
2
64