Show Power Inline Consumption - Cisco 300 Series Cli Manual

Power over Ethernet (PoE) Commands
OL-32830-01 Command Line Interface Reference Guide
Following is a list of port status values:
Port is off – Underload disconnect detected
Port is off – Overload detected
Port is off – Short detected
Port is off - Invalid PD resistor signature detected
Port is on - Valid PD resistor signature detected
Port is off - Power was denied
Port is on - Valid capacitor signature detected
Port is off - Backoff state has occurred
Port is off - Class error has occurred

36.11 show power inline consumption

To display information about the inline power consumption for all interfaces or for a
specific interface, use the show power inline consumption privileged EXEC mode
command.
Syntax
show power inline consumption
Parameters
•
Interface-id—Specifies an interface ID. The interface ID must be an Ethernet
port.
Default Configuration
Show information for all ports.
Command Mode
Global Configuration mode
[interface-id ]
36
734