Show Dot1X - Cisco 300 Series Cli Manual

2
77
User Guidelines
The command is relevant only for single-host mode.
For BPDU messages whose MAC addresses are not the supplicant MAC address
are not discarded in Protect mode.
BPDU message whose MAC addresses are not the supplicant MAC address
cause a shutdown in Shutdown mode.
Example
switchxxxxxx(config)#
switchxxxxxx(config-if)#

2.31 show dot1x

Use the show dot1x Privileged EXEC mode command to display the 802.1X
interfaces or specified interface status.
Syntax
show dot1x [interface
Parameters
•
interface-id
—Specifies an Ethernet port.
•
detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Display for all ports. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Examples
The following example displays authentication information for all interfaces of the switch
supporting the full multi-sessions mode:
switchxxxxxx#
show dot1x
interface gi11
dot1x violation-mode protect
interface-id |
detailed]
OL-32830-01 Command Line Interface Reference Guide
802. 1 X Commands