Cisco 300 Series Cli Manual page 113

4
113
[log-input]
igmp {any | source source-wildcard} {any | destination
no permit
destination-wildcard}[igmp-type] [dscp number | precedence number] [
time-range-name]
[log-input]
{any | source source-wildcard} {any| s ource-port/port-range}{any |
no permit tcp
destination destination-wildcard} {any| d estination-port/port-range} [dscp number |
precedence number] [match-all list-of-flags] [
[log-input]
{any | source source-wildcard} {any| s ource-port/port-range} {any |
no permit udp
destination destination-wildcard} {any| d estination-port/port-range} [dscp number |
precedence number] [
[log-input]
Parameters
•
permit protocol
protocol names are: icmp, igmp, ip, tcp, egp, igp, udp, hmp, rdp, idpr, ipv6,
ipv6:rout, ipv6:frag, idrp, rsvp, gre, esp, ah, ipv6:icmp, eigrp, ospf, ipinip, pim,
l2tp, isis. To match any protocol, use the ip keyword.(Range: 0–255)
•
source
—Source IP address of the packet.
•
source-wildcard
ones in the bit position that you want to be ignored.
•
destination
—Destination IP address of the packet.
•
destination-wildcard
address. Use ones in the bit position that you want to be ignored.
•
priority
- Specify the priority of the access control entry (ACE) in the access
control list (ACL). "1" value represents the highest priority and "2147483647"
number represents the lowest priority.(Range: 1-2147483647)
•
number
dscp —Specifies the DSCP value.
•
number
precedence
•
icmp-type
—Specifies an ICMP message type for filtering ICMP packets.
Enter a number or one of the following values: echo-reply,
destination-unreachable, source-quench, redirect, alternate-host-address,
echo-request, router-advertisement, router-solicitation, time-exceeded,
parameter-problem, timestamp, timestamp-reply, information-request,
time-range time-range-name]
—The name or the number of an IP protocol. Available
—Wildcard bits to be applied to the source IP address. Use
—Wildcard bits to be applied to the destination IP
—Specifies the IP precedence value.
OL-32830-01 Command Line Interface Reference Guide
time-range-name]
time-range
ACL Commands
time-range