Sntp Source-Interface-Ipv6 - Cisco 300 Series Cli Manual

9
Clock Commands
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address belonging
to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 SNTP server.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)# sntp source-interface vlan 10
9.16

sntp source-interface-ipv6

To specify the source interface whose IPv6 address will be used ad the Source
IPv6 address for communication with IPv6 SNTP servers, use the sntp
source-interface-ipv6 command in Global Configuration mode. To restore the
default configuration, use the no form of this command.
Syntax
interface-id
sntp source-interface-ipv6
no sntp source-interface-ipv6
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address defined of the outgoing interface and
selected in accordance with RFC6724.
243 OL-32830-01 Command Line Interface Reference Guide