Snmp-Server Location - Cisco 300 Series Cli Manual

45
Network Management Protocol (SNMP) Commands
Syntax
text
snmp-server contact
no snmp-server contact
Parameters
text—Specifies system contact information. (Length: 1–160 characters)
Default Configuration
None
Command Mode
Global Configuration mode
Example
The following example sets the system contact information to Technical_Support.
switchxxxxxx(config)# snmp-server contact Technical_Support

45.21 snmp-server location

To set the value of the system location string, use the snmp-server location Global
Configuration mode command. To remove the location string, use the no form of
this command.
Syntax
text
snmp-server location
no snmp-server location
Parameters
text—Specifies the system location information. (Length: 1–160 characters)
Default Configuration
None
883 OL-32830-01 Command Line Interface Reference Guide