Cisco 300 Series Cli Manual page 629

27
629
Parameters
•
interface-id
—Specifies the identifier of the interface from which IPv6
neighbor information is to be displayed.
•
ipv6-address
—Specifies the IPv6 address of the neighbor. This argument
must be in the form documented in RFC4293 where the address is
specified in hexadecimal using 16-bit values between colons.
•
ipv6-hostname
device.
Default Configuration
All IPv6 ND cache entries are listed.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
interface-id
When the
neighbors is displayed. Specifying the
information about the specified interface.
Examples
Example 1. The following is sample output from the show ipv6 neighbors
command when entered with an interface-id:
switchxxxxxx# show ipv6 neighbors vlan 1
IPv6 Address
2000:0:0:4::2
3001:1::45a
FE80::203:A0FF:FED6:141E
Example 2. The following is sample output from the show ipv6 neighbors
command when entered with an IPv6 address:
switchxxxxxx# show ipv6 neighbors 2000:0:0:4::2
—Specifies the IPv6 host name of the remote networking
argument is not specified, cache information for all IPv6
interface-id
Age Link-layer Addr
0 0003.a0d6.141e
- 0002.7d1a.9472
0 0003.a0d6.141e
OL-32830-01 Command Line Interface Reference Guide
IPv6 Commands
argument displays only cache
State Interface Router
REACH VLAN1
REACH VLAN1
REACH VLAN1
Yes
-
No