Qos Statistics Aggregate-Policer - Cisco 300 Series Cli Manual

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide
no qos statistics policer
Parameters
•
policy-map-name—Specifies the policy map name.
•
class-map-name—Specifies the class map name.
Default Configuration
Counting in-profile and out-of-profile is disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example enables counting in-profile and out-of-profile on the
interface.
switchxxxxxx(config)#
switchxxxxxx(config-if)# qos statistics policer

39.37 qos statistics aggregate-policer

Use the qos statistics aggregate-policer Global Configuration mode command to
enable counting in-profile and out-of-profile. Use the no form of this command to
disable counting.
Syntax
qos statistics aggregate-policer
no qos statistics aggregate-policer
Parameters
aggregate-policer-name—Specifies the aggregate policer name.
Default Configuration
Counting in-profile and out-of-profile is disabled.
policy-map-name class-map-name
interface 1
gi1
aggregate-policer-name
aggregate-policer-name
policy1 class1
39
784