Bridge Multicast Forbidden Source Group - Cisco 300 Series Cli Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide
•
interface-list
ethernet
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
•
port-channel-list
port-channel
Separate nonconsecutive port-channels with a comma and no spaces; use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
You can execute the command before the VLAN is created.
Example
The following example registers a source IP address - Multicast IP address pair to
the bridge table:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
5.8

bridge multicast forbidden source group

To forbid adding or removing a specific IP source address - Multicast address pair
to or from specific ports, use the bridge multicast forbidden source group
IInterface (VLAN) Configuration mode command. To return to the default
configuration, use the no form of this command.
Syntax
bridge multicast forbidden
remove} {ethernet interface-list | port-channel port-channel-list}
no bridge multicast forbidden source
—(Optional) Specifies a list of Ethernet ports.
—(Optional) Specifies a list of port channels.
interface vlan 8
bridge multicast source 13.16.1.1 group 239.2.2.2
source ip-address group ip-multicast-address
ip-address ip-multicast-address
group
5
add |
{
150