Cisco 300 Series Cli Manual page 715

34
715
Syntax
show ipv6 mld snooping groups [vlan
ipv6-address
[source
Parameters
•
vlan-id
vlan —(Optional) Specifies the VLAN ID.
•
address ipv6-multicast-address
address.
•
ipv6-address
source
Command Mode
User EXEC mode
Default Configuration
Display information for all VLANs and addresses defined on them.
User Guidelines
To see the full multicast address table (including static addresses), use the
bridge multicast address-table
The Include list contains the ports which are in a forwarding state for this group
according to the snooping database. In general, the Exclude list contains the ports
which have issued an explicit Exclude for that specific source in a multicast group.
The Reporters That Are Forbidden Statically list contains the list of ports which
have asked to receive a multicast flow but were defined as forbidden for that
multicast group in a multicast bridge.
Note: Under certain circumstances, the Exclude list may not contain accurate
information; for example, in the case when two Exclude reports were received on
the same port for the same group but for different sources, the port will not be in
the Exclude list but rather in the Include list
vlan-id
]
—(Optional) Specifies the IPv6 multicast
—(Optional) Specifies the IPv6 source address.
command.
OL-32830-01 Command Line Interface Reference Guide
MLD Snooping Commands
ipv6-multicast-address
] [address ]
show