Cisco 300 Series Cli Manual page 626

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

IPv6 Commands

OL-32830-01 Command Line Interface Reference Guide

FF02::1:FF11:6770

is 1500 bytes

ICMP error messages limited interval is 100ms; Bucket size is 10 tokens

ND DAD is disabled, number of DAD attempts: 1

ND reachable time is 30000 milliseconds

MLD Version is 2

Tunnel mode is ISATAP

Tunnel Local IPv4 address : 10.10.10.1(VLAN 1)

ISATAP Router DNS name is isatap

Field Descriptions:

ND DAD—The state of duplicate address detection on the interface

(enabled or disabled). Note. The state of duplicate address detection on an

IPv6 tunnel interface of ISATAP type always is displayed as disabled

regardless of a value of the number of DAD attempts parameter because

DAD is not supported on NBMA interfaces. The switch will enable DAD

automatically when the user change the type of the tunnel to manual if a the

parameter value bigger than 0.

number of DAD attempts:—Number of consecutive neighbor solicitation

messages that are sent on the interface while duplicate address detection

is performed.

vlan 1 is up/up—Indicates the interface status: administrative/operational.

IPv6 is enabled, stalled, disabled (stalled and disabled are not shown in

sample output)—Indicates that IPv6 is enabled, stalled, or disabled on the

interface. If IPv6 is enabled, the interface is marked "enabled." If duplicate

address detection processing identified the link-local address of the

interface as being a duplicate address, the processing of IPv6 packets is

disabled on the interface and the interface is marked "stalled." If IPv6 is not

enabled, the interface is marked "disabled."

link-local address—Displays the link-local address assigned to the

Global Unicast address(es):—Displays the global Unicast addresses

assigned to the interface. The type is manual or autoconfig.

Joined group address(es):—Indicates the Multicast groups to which this

interface belongs.