Back-Pressure; Port Jumbo-Frame - Cisco 300 Series Cli Manual

Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide

18.11 back-pressure

To enable back pressure on a specific interface, use the back-pressure Interface
(Ethernet) Configuration mode command. To disable back pressure, use the no
form of this command.
Syntax
back-pressure
no back-pressure
Parameters
This command has no arguments or keywords
Default Configuration
Back pressure is disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Back-pressure cannot be enabled when EEE is enabled.
Example
The following example enables back pressure on port gi 1 1.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

18.12 port jumbo-frame

To enable jumbo frames on the device, use the port jumbo-frame Global
Configuration mode command. To disable jumbo frames, use the no form of this
command.
.
interface gi11
back-pressure
18
398