25
589
Example 3—The following example displays the user defined policies:
switchxxxxxx#
show ipv6 neighbor binding policy
policy1
policy2
25.78 show ipv6 neighbor binding prefix table
To display contents of the Neighbor Prefix table, use the show ipv6 neighbor
binding prefix table command in Privilege EXEC configuration mode.
Syntax
show ipv6 neighbor binding prefix table [vlan
Parameters
•
vlan-id
vlan
—Displays the prefixes that match the specified VLAN.
Command Mode
Privileged EXEC mode
User Guidelines
This command displays the Neighbor Prefix table. The display output can be
limited to the specified VLAN. If no VLAN is configured, all prefixes are displayed.
Example
The following example displays the learned prefixes:
switchxxxxxx#
show ipv6 neighbor binding prefix table
Flags: A - the prefix can be used for autoconfig (stateless configuration)
Neighbor Prefix Table has 4 entries
VLAN
Prefix
7
2004:1::/64
static
7
2006:1::/64
dynamic
7
2008:1::/64
static
Type
Flags
Remaining Lifetime
A
OL-32830-01 Command Line Interface Reference Guide
IPv6 First Hop Security
vlan-id
]
1230