Ipv6 Mld Snooping Vlan Querier Version - Cisco 300 Series Cli Manual

34
709
If the MLD Querier election mechanism is enabled, the MLD Snooping querier
supports the standard MLD Querier election mechanism specified in RFC2710
and RFC3810.
If MLD Querier election mechanism is disabled, MLD Snooping Querier delays
sending General Query messages for 60 seconds from the time it was enabled.
During this time, if the switch did not receive an IGMP query from another Querier
- it starts sending General Query messages. Once the switch acts as a Querier, it
will stop sending General Query messages if it detects another Querier on the
VLAN. In this case, the switch will resume sending General Query messages if it
does hear another Querier for Query Passive interval that equals to
<Robustness>*<Query Interval> + 0.5*<Query Response Interval).
See the ipv6 mld robustness,
query-max-response-time
It is recommended to disable MLD Querier election mechanism if there is an IPMv6
Multicast router on the VLAN.
Example
The following example disables MLD Snooping Querier election on VLAN 1:
switchxxxxxx(config)# no ipv6 mld snooping vlan 1 querier election

34.6 ipv6 mld snooping vlan querier version

To configure the IGMP version of an IGMP querier on a specific VLAN, use the ipv6
mld snooping vlan querier version command in Global Configuration mode. To
return to the default, use the no form of this command.
Syntax
ipv6 mld snooping vlan
no ipv6 mld snooping vlan
Parameters
•
vlan-id —Specifies the VLAN.
•
querier version {1
ipv6 mld query-interval, and
commands for configurations of these parameters.
vlan-id querier version {1
vlan-id querier version
|
2}—Specifies the MLD version.
OL-32830-01 Command Line Interface Reference Guide
MLD Snooping Commands
ipv6 mld
| 2}