Dot1X Reauthentication; Dot1X System-Auth-Control - Cisco 300 Series Cli Manual

2
65
Example
The following command manually initiates re-authentication of 802.1X-enabled
gi 1 1:
switchxxxxxx#
dot1x re-authenticate gi11
2.18

dot1x reauthentication

Use the dot1x reauthentication Interface Configuration mode command to enable
periodic re-authentication of the client. Use the no form of this command to return
to the default setting.
Syntax
dot1x reauthentication
no dot1x reauthentication
Parameters
N/A
Default Configuration
Periodic re-authentication is disabled.
Command Mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)#
switchxxxxxx(config-if)#
2.19

dot1x system-auth-control

Use the dot1x system-auth-control Global Configuration mode command to
enable 802.1X globally. Use the no form of this command to restore the default
configuration.
interface gi11
dot1x reauthentication
OL-32830-01 Command Line Interface Reference Guide
802. 1 X Commands