Macro Auto Processing Lldp - Cisco 300 Series Cli Manual

44
Smartport Commands
Default Configuration
Enabled
Command Mode
Global Configuration mode
Example
To enable CDP globally:
switchxxxxxx(config)# macro auto processing cdp

44.8 macro auto processing lldp

The macro auto processing lldp Global Configuration mode command enables
using the LLDP capability information to identify the type of an attached device.
When Auto Smartport is enabled on an interface and this command is run, the
switch automatically applies the corresponding Smartport type to the interface
based on the LLDP capabilities advertised by the attaching device(s).
The no format of the command disables the feature.
Syntax
macro auto processing lldp
no macro auto processing lldp
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Global Configuration mode
843 OL-32830-01 Command Line Interface Reference Guide