Dot1X Radius-Attributes Vlan - Cisco 300 Series Cli Manual

802. 1 X Commands
OL-32830-01 Command Line Interface Reference Guide
stations, in order to proceed to the forwarding state immediately after successful
authentication.
Example
The following example sets 802.1X authentication on gi 1 1 to auto mode.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
2.16

dot1x radius-attributes vlan

Use the dot1x radius-attributes vlan Interface Configuration mode command to
enable RADIUS-based VLAN assignment. Use the no form of this command to
disable RADIUS-based VLAN assignment.
Syntax
dot1x radius-attributes vlan [reject | static]
no dot1x radius-attributes vlan
Parameters
•
reject—If the RADIUS server authorized the supplicant, but did not provide
a supplicant VLAN the supplicant is rejected. If the parameter is omitted,
this option is applied by default.
•
static—If the RADIUS server authorized the supplicant, but did not provide
a supplicant VLAN, the supplicant is accepted.
Default Configuration
reject
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
If RADIUS provides invalid VLAN information, the authentication is rejected.
interface gi11
dot1x port-control auto
2
62