Tacacs-Server Host Source-Interface-Ipv6 - Cisco 300 Series Cli Manual

51
TACACS+ Commands
Syntax
interface-id
tacacs-server host source-interface
no tacacs-server host source-interface
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address belonging
to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 TACACS+ server.
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)# tacacs-server host source-interface vlan 100
51.3 tacacs-server host
source-interface-ipv6
To specify the source interface whose IPv6 address will be used as the Source
IPv6 address for communication with IPv6 TACACS+ servers, use the
tacacs-server host source-interface-ipv6 Global Configuration mode command.
To restore the default configuration, use the no form of this command.
999 OL-32830-01 Command Line Interface Reference Guide