Lldp Optional-Tlv 802.1 - Cisco 300 Series Cli Manual

30
659

30.16 lldp optional-tlv 802.1

To specify whether to transmit the 802.1 TLV, use the lldp optional-tlv 802.1
Interface (Ethernet) Configuration mode command. To revert to the default setting,
use the no form of this command.
Syntax
lldp optional-tlv 802.1 pvid
advertised.
no lldp optional-tlv 802.1 pvid - The PVID advertise state is returned to default.
lldp optional-tlv 802.1 ppvid
advertised. The PPVID is the PVID that is used depending on the packet's protocol.
lldp optional-tlv 802.1 ppvid
lldp optional-tlv 802.1 vlan
lldp optional-tlv 802.1 vlan
lldp optional-tlv 802.1 protocol
The protocols selected are advertised.
lldp optional-tlv 802.1 protocol
- The protocols selected are not advertised.
Parameters
•
lldp optional-tlv 802.1 pvid
the PVID of the port.
•
lldp optional-tlv 802.1 ppvid add/remove
advertising. (range: 0–4094). PPVID = 0 indicates that the port is not
capable of supporting port and protocol VLANs and/or the port is not
enabled with any protocol VLANs.
•
vlan-id
add/remove
•
{stp | rstp | mstp | pause | 802.1x | lacp | gvrp}
add/remove
advertise the specified protocols; remove specifies not to advertise the
specified protocol.
Default Configuration
The following 802.1 TLV is transmitted:
Link Layer Discovery Protocol (LLDP) Commands
{enable | disable}
- The PVID is advertised or not
add ppvid
- The Protocol Port VLAN ID (PPVID) is
remove ppvid
- The PPVID is not advertised.
add vlan-id vlan-id
- This
remove vlan-id
- This
add {stp | rstp | mstp | pause | 802.1x | lacp | gvrp}
remove {stp | rstp | mstp | pause | 802.1x | lacp | gvrp}
{enable | disable}
—Adds/removes VLAN for advertising (range: 0–4094).
OL-32830-01 Command Line Interface Reference Guide
is advertised.
vlan-id
is not advertised.
—Advertises or stop advertize
ppvid —Adds/removes PPVID for
—Add specifies to
-