BIOS Setup Utility
Exit
Exit
When you have made all of your selections from the various menus within the Setup
Utility, you must save your changes and exit. Selecting EXIT from the Menu Bar
selects the EXIT menu.
Exit Saving Changes
If you have made any changes to CMOS settings, use this selection to ensure that the
changes you made are saved in CMOS RAM. CMOS RAM is a type of non-volatile
RAM whose content is protected by the Lithium coin cell on the Eclipse System
Board.
When you select this option, a confirmation is requested. Select [Yes] to save changes
to CMOS RAM, exit CMOS Setup, and restart the workstation.
You may also press [F10], then [Enter] from any menu to save changes and reboot the
workstation.
Exit Discarding Changes
Use this option only if you do not want to save any of the changes you have made in
the Setup Utility. If you have made changes to any fields other than the system time,
date, and password, a confirmation appears.
Load Setup Defaults
This option allows you to load default values into each parameter of all Setup menus.
When this option is selected, or the [F9] key pressed, confirmation is requested. Select
[Yes] to load default values. You may either Exit Saving Changes now or continue to
make changes before saving the values to CMOS RAM and exiting.
Discard Changes
This option allows you to discard any selections you have made, and restore the
previous values. When you select this option, a confirmation is requested. Select [Yes]
to discard any settings you have changed, but not restart the workstation.
Save Changes
This option allows you to save your current selections without exiting the Setup
Utility, allowing you to return to other menus and make changes. When you select this
option, a confirmation is requested. Select [Yes] to save any changes to CMOS RAM.
2-14
PCWS Eclipse Setup Guide
Need help?
Do you have a question about the Eclipse and is the answer not in the manual?