BIOS Setup Utility
Starting the Phoenix Setup Utility/Checking the MICROS BIOS Version
Starting the Phoenix Setup Utility/Checking the MICROS BIOS
Version
The following procedure describes how to determine the MICROS BIOS Version
number of the Eclipse and how to enter the BIOS Setup Utility.
Requirements:
A PC Keyboard with a PS/2 style connector.
Procedure:
1. Attach a PS/2 keyboard to the front panel connector and the AC power cable to
the power supply.
2. Press the power button located on the right side of the unit.
3. To check the MICROS BIOS Version, wait about 20 seconds for the BIOS Splash
screen to appear, then the [Pause/Break] key to freeze the display. The fourth line
from the top of the screen indicates the MICROS BIOS Version in the form of
v1.xx.xx. This manual documents additions and changes to the BIOS up to
Version 1.00.22, and is current through November 2004.
4. To enter the CMOS Setup Utility, press the [F2] key when prompted.
You should be at the PhoenixBIOS Setup Utility main screen.
o
For information on how to navigate each menu and make selections, press
o
[F1] or check the help information at the bottom of the screen.
There are five primary sections: Main, Advanced, Power, Boot, and Exit. An
o
overview of each selection follows.
Main
This menu lets you set the system date and time, define the type of hard disk installed,
and display the total amount of memory installed on the system board.
Advanced
This menu provides access to settings for the Eclipse COM ports, LPT port, and mag
card reader.
Power
This menu provides access to the Eclipse power saving modes. A pre-configured
power saving mode may be used or the user may configure a power saving mode
manually by defining several parameters. Power settings are disabled by default.
2-2
PCWS Eclipse Setup Guide
Need help?
Do you have a question about the Eclipse and is the answer not in the manual?