PCWS Eclipse Hardware Configuration
Installing a Disk On Chip
Installing a Disk On Chip
This procedure describes how to install and configure the Optional Disk On Chip.
Procedure:
1.
Refer to page 3-2 and remove the Eclipse system unit cover if you have not done
so already.
2.
Refer to Figure 3-45 and remove the screw that holds the hard disk bracket in
place. Remove the hard disk (if installed) and bracket from the system unit and set
it aside.
3-32
STATIC SENSITIVE DEVICES
Always follow ESD procedures when handling and installing
the Disk On Chip.
Figure 3-45: Removing the Hard Disk Bracket
PCWS Eclipse Setup Guide
Need help?
Do you have a question about the Eclipse and is the answer not in the manual?