Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
1 Connector
2 Ignition coil
IGNITION COIL INSPECTION [Z6]
IGNITION COIL WITH BUILT-IN POWER SWITCH INSPECTION
1. Remove the ignition coil connector.
2. Measure the resistance between each terminal on the ignition coil connector.
• If the measurement corresponds to the table, replace the ignition coil.
Tester Connection Position
Item
Positive
C
B
Terminal
A
B
A
C
Downloaded from
Negative
∞ or 0 ohm is not normal
0 to several kilohm (continuity) is not normal
https://carmanualshub.com/
Condition
- automotive repair manuals website
B3E011801009W05