Checking Network Connection - Canon imageRUNNER ADVANCE C5255 Series Service Manual

<Reversal Trail-edge Guide>
1) Install the Reversal Trail-edge Guide to the delivery assembly.
• 2 claws
Reversal Trail-edge Guide
x2
9
Installation > Installation Procedure > Checking Network Connection > Checking Network Connection

Checking Network Connection

■ Overview
If the user network environment is TCP/IP, use Ping function to check that the network setting
is properly executed.
If the user network environment is IPX/SPX or Apple Talk, skip this procedure.
■ Checking Network Connection
CAUTION:
Use the network cable of rank 5e or higher. In addition, use of shield type (STP cable)
is recommended.
When non-shield type (UTP cable) is used, the surrounding electronic equipments may
be interfered via the network cable.
1) Turn OFF the main power switch.
F-9-83
2) Connect the network cable to the host machine and turn ON the main power switch.
3) Inform the system administrator at the installation site that the installation of the host
machine is complete, and ask for network connection of the host machine.
NOTE:
Network setting cannot be executed unless logging in as an administrator.
Factory default password is as follows.
•
•
CAUTION:
Following setting needs to be ON to perform network setting:
• [Settings/Registration] > [Preferences] > [Network] > [Confirm Network Connection
• [Settings/Registration] > [Preferences] > [Network] > [TCP/IP Settings] > [IPv4
4) Turn OFF the main power switch.
5) Turn ON the main power switch.
9 Installation > Installation Procedure > Checking Network Connection > Checking Network Connection
System administration division ID: 7654321
System administration password: 7654321
Set. Changes]
Settings] > [Use IPv4]
9-38
9-38