Main Unit - Front And Rear Panels; D Microphone Connector Information - Icom ID-5100A Full Manual

Previous view
1
PANEL DESCRIPTION
Main unit — Front and rear panels
q
q SD CARD SLOT [SD CARD]
Insert an SD card (purchase separately). (p. 9-4)
w CONTROLLER CONNECTOR [CONTROLLER]
Connects to the Controller using the supplied control
cable.
e MICROPHONE CONNECTOR [MIC]
Plug in the supplied microphone (HM-207) or the op-
tional microphone (HM-154).
r ANTENNA CONNECTOR
Connect a 50 ø impedance of antenna with a PL-
259 connector.
The transceiver has a built-in duplexer, so you can
use a 144 and 430 MHz dual-band antenna without
needing an external duplexer.
t COOLING FAN
The cooling fan for heat dissipation.
You can select the Fan control option in the Menu
screen; automatically starts to rotate when you be-
gin transmitting, or continuously rotates from power
ON.
y DATA JACK [DATA]
Connect a PC through the optional data communica-
tion cable, for cloning (p. 13-12) or low-speed data
communication (p. 7-15) in the DV mode.

D Microphone connector information

MIC
PIN No.
1
2
3
4
5
8 7 6 5 4 3 2 1
6
Front panel view
7
8
w e
NAME
8 V +8 V DC output.
MIC U/D Frequency Up/Down
HM-207 connection
M8V SW
Grounds when the HM-207 is connected.
PTT
PTT input
MIC E Microphone ground
MIC
Microphone input
GND PTT ground
DATA IN When the HM-207 is connected; inputs HM-207 data
r
u EXTERNAL SPEAKER JACK 1 [SP1]
i EXTERNAL SPEAKER JACK 2 [SP2]
Connect to an 8 ohm external speaker.
➥
• When you connect external speakers to [SP1]
and [SP2], the A band (left side display) audio
is heard from [SP1] and the B band (right side
display) audio is heard from [SP2].
• When you connect an external speaker to [SP1],
the A and B band audio is heard from [SP1]. In
this case, the internal speaker is disabled.
• When you connect an external speaker to [SP2],
the A band (left side display) audio is heard from
the internal speaker and the B band (right side
display) audio is heard from the external speak-
er.
The [SP2] jack is used for external control of the
➥
transceiver.
• Connect a PC, using the optional CT-17
level converter
transceiver.
• Use for the transceive function with another Icom
CI-V transceiver or receiver. When the transceive
function is set to ON, changing the frequency,
operating mode and so on, on the ID-5100A/E
automatically changes those settings on other
Icom transceivers or receivers, and vice versa.
o DC POWER SOCKET [DC 13.8V]
Connect 13.8 V DC power source through the sup-
plied DC power cable.
DESCRIPTION
1-7
o
t y u i
, for external control of the
SPECIFICATIONS
Maximum 10 mA
UP: Ground
DN: Ground through 470 ˘
—
Ground for transmission
—
—
—
—
-
ci v