Icom ID-5100A Full Manual page 231

Previous view
12
MENU SCREEN
Menu items and Default settings (Continued)
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
Opening Message
Voltage (Power ON)
Display Unit
Latitude/Longitude
Altitude/Distance
Speed
Temperature
Barometric
Rainfall
Wind Speed
Display Language
System Language
Sounds
Beep Level
Key-Touch Beep
Home CH Beep
Band Edge Beep
Scan Stop Beep
Standby Beep
Sub Band Mute
Scope AF Output
Time Set
Date/Time
DATE
TIME
GPS Time Correct
UTC Offset
Auto Power OFF
2
SD Card*
Load Setting
File selection
Save Setting
<<New File>>
File selection
* 1 The default value may differ, depending on the transceiver version.
2
* Be sure to insert the SD card into the transceiver before selecting these items.
OFF or ON
OFF or ON
ddd°mm.mm', ddd°mm'ss"
m, ft/ml* 1
km/h, mph* 1 or knots
1
ç, ƒ*
hPa, mb, mmHg, inHg* 1
mm, inch* 1
m/s, mph* 1 , knots
English or Japanese
English or Japanese
Sets the Sound options.
0~9
OFF or ON
OFF or ON
OFF or ON
OFF or ON
OFF, ON or ON (to me:High Tone)
OFF, Mute, Beep or Mute & Beep
OFF or ON
Sets the Time options.
2000/01/01~2099/12/31
0:00~23:59
OFF or Auto
–14:00~±0:00~+14:00
OFF, 30min, 60min, 90min or
120min
Sets the SD card options.
ALL, Except My Station,
Repeater List Only
12-9
Selects whether or not to display the opening mes-
sage at power ON.
Selects whether or not to display the voltage of the
external DC power source at power ON.
Selects position format to display the position.
Selects units to display the distance and altitude.
Selects units to display the speed.
Selects units to display the temperature.
Selects units to display the barometric pressure.
Selects units to display the rainfall.
Selects units to display the wind speed.
Selects the display language in the DR screen or
Menu mode. When "English" is selected in System
Language, this setting will disappear.
Selects English or Japanese as the system language
of the transceiver.
Sets the beep output level.
Turns the confirmation beep tones when key is
pushed, ON or OFF.
Turns the Home CH Beep ON or OFF.
Turns the Band edge beep ON or OFF.
Turns the scan stop beep ON or OFF.
Turns the standby beep function in the DV mode ON
or OFF.
Selects to mute the SUB band audio signal while
receiving on the MAIN band, and/or sound a beep
when a signal disappears on the SUB band.
Selects the audio output option during a sweep.
Sets the current date.
Sets the current time.
Sets to automatically correct the time using a GPS
signal.
Enters the time difference between UTC and the lo-
cal time.
Turns the Auto power OFF function ON or OFF.
Loads the settings file to the transceiver.
Saves the settings as a new file.
Saves the settings in a selected file.