Main Unit - Front And Rear Panels - Icom ID-5100A Basic Manual

1
PANEL DESCRIPTION
■ Main unit — Front and rear panels
q SD CARD SLOT [SD CARD]
Insert an SD card (purchase separately). (p. 52)
w CONTROLLER CONNECTOR [CONTROLLER]
Connects to the Controller using the supplied control cable.
e MICROPHONE CONNECTOR [MIC]
Plug in the supplied microphone (HM-207) or the optional
microphone (HM-154).
r ANTENNA CONNECTOR
Connect a 50 ø impedance of antenna with a PL-259 con-
nector.
The transceiver has a built-in duplexer, so you can use a
144 and 430 MHz dual-band antenna without needing an
external duplexer.
t COOLING FAN
The cooling fan for heat dissipation.
You can select the Fan control option in the Menu screen,
and automatically starts to rotate when you begin transmit-
ting, or continuously rotates from power ON.
7
q w e r t
y DATA JACK [DATA]
Connect a PC through the optional data communication
cable, for cloning or low-speed data communication in the
DV mode. (Section 13 of the Full Manual)
u EXTERNAL SPEAKER JACK 1 [SP1]
i EXTERNAL SPEAKER JACK 2 [SP2]
Connect to an 8 ohm external speaker.
➥
• When you connect external speakers to [SP1] and
[SP2], the A band (left side display) audio is heard
from [SP1] and the B band (right side display) audio is
heard from [SP2].
• When you connect an external speaker to [SP1], the
A and B band audio is heard from [SP1]. In this case,
the internal speaker is disabled.
• When you connect an external speaker to [SP2], the
A band (left side display) audio is heard from the inter-
nal speaker and the B band (right side display) audio
is heard from the external speaker.
The [SP2] jack is used for external control of the trans-
➥
ceiver. (Section 1 of the Full Manual)
o
y u i