Mounting The Head Support Holder; Mounting An Additional Connecting Bridge - Otto Bock Kimba Neo Instructions For Use Manual

12

6.1.3.2 Mounting the head support holder

1) Insert the mounting screws through the bore holes in the back support and the head support holder.
2) Place the cap nuts on the reverse side.
3) Tighten the screw connections (see fig. 14).

6.1.3.3 Mounting an additional connecting bridge

An additional connecting bridge may have to be installed to achieve anatomically correct support for the head.
1) Loosen the mounting screws on the back support and head support holder (see fig. 14).
2) Unscrew the head support holder from the connecting bridge and attach it to the additional connecting bridge
(see fig. 15, item 1).
3) Push the connecting bridges together (see fig. 15, item 2).
4) Put on a washer (see fig. 16, item 1) and screw the connecting bridges together using the thumbscrew (see
fig. 17, item 1).
5) Mount the assembly on the back support (see Page 11).
14
16
Kimba Neo
13
15
17
Installing options/accessories
11