Connecting External Switches - Otto Bock Skippi Plus Service Manual

Fig. 51 Holder with attached push-button module
3. Connect both plugs to the sockets on the seat module (see Fig. 52 and section 8.3, RSW
connector).
4. Insert the batteries.
5. Switch on the control unit.
6. Test the functionality of the push-button module.
Properly reassemble all components upon completion of the work.
Fig. 52 Push-button module connections on the seat module
1 2-pin plug for 12 V power supply
2 12-pin plug for signals (RSW connector)

6.17.4 Connecting external switches

The push-button module has three inputs on the underside for connecting external switches,
e.g. Buddy Buttons.
Preparation:
U Turn the control unit off.
U Remove the batteries (see section 6.3).
Steps:
1. Remove the protective pin from the input on the push-button module.
2. Plug the Buddy Button connection cable into the input on the push-button module.
Skippi Plus
1
Service Work
2
Ottobock | 45