Table of Contents
Advertisement
Use
INFORMATION
Please contact the qualified personnel for subsequent adjustment of the control panel position.
The arm supports offer the user support for the forearms.
7.2.1 Removing/installing the arm supports
The arm supports can be removed if necessary.
4
7.2.2 Folding the arm supports up/down
To make it easier to get in the wheelchair from the side, the arm supports can be folded back if necessary.
5
7.2.3 Adjusting the arm supports
The height of the forearm supports can be adjusted by the user (see previous section).
In addition, qualified personnel can subsequently adjust the depth position and the width setting of the forearm
supports.
7.3 Leg support
The user can place their feet on the central leg support.
The height of the foot plate has been adjusted by qualified personnel to the length of the user's lower legs. The
angle of the foot plate has been set by qualified personnel so that it allows the ankles to rest in a comfortable posi
tion.
14
Removing the arm support
1) Pull out the clamping pins (clamps) by hand (see
fig. 4, item 1).
2) Pull the arm support up and out, and lay it aside
(see fig. 4, item 2).
3) Only for arm support with control panel:
→ Turn the control device off (see page 16).
→ For transporting the power wheelchair, place
the arm support on the seat.
Installing the arm support
1) Insert the arm support into the guide and move it to
the desired height (see fig. 4, item 2).
INFORMATION: There is a retaining plate on
the underside of the arm pad. The curvature on
this plate always faces out when the arm sup
port is installed.
2) Reinsert the clamping pins (clamps) (see fig. 4,
item 1).
Swinging the arm supports forward or back
1) Grasp the arm support with your hand.
2) Fold up the arm support towards the back to the
stop (see fig. 5, item 1).
3) After getting in, fold the arm supports back down
before driving.
490E163=*
Advertisement
Table of Contents
