Mounting The Padding; Installing Options/Accessories - Otto Bock Kimba Neo Instructions For Use Manual

5.1.2 Mounting the padding

INFORMATION
► If necessary: Before applying the back support pads, all required components have to be installed on the
frame tubes of the back support insert. First mount the canopy adapters (see Page 27) and support pads,
only then the pads.
► Adjust the seating unit prior to mounting the pads (see Page 31 ff).
► If the product was ordered without padding, please note the information in the section "Delivery without
padding" (see Page 29).
a) Mounting the back support pad
1) Open the zip on the pad.
2) Pull the pad with its cap over the back support and close the zip (see fig. 6).
3) Pull the lower end of the pad through between the back support and seat bottom.
4) Close the twist lock (see fig. 7).
5) Push the pad under the support pads at the sides (see fig. 8).
b) Mounting the seat pad
1) Attach the pad with the hook-and-loop fastener (see fig. 9).
2) Push the pad under the support pads at the sides (see fig. 8).
6
8

6 Installing options/accessories

INFORMATION
Please also observe the adjustment instructions in the section "Settings" (see Page 31 ff.).
Kimba Neo
7
9
Installing options/accessories
9