Swing-Away Control Panel Holder; Adjusting The Angle (Delta Control Panel); Fig. 34 Height Adjustment Of Control Panel Holder; Fig. 35 Swing-Away Control Panel Holder - Otto Bock C1000 Instructions For Use Manual

fig. 34 height adjustment of control panel holder
8.4.2 Swing-away control Panel holder
To allow the user to drive the power wheelchair closer to
an object or under the edge of a table, the control panel
can be swung to the side with a special control panel
holder (see fig. 35).
Apply a little bit of pressure to press the control
❒
panel holder to the side and release the pivot
element.
Swing the control panel holder to the side.
❒
When bringing the control panel holder back to its
❒
original position, the pivot element automatically
locks into place.
C1000
fig. 35 Swing-away control panel holder
8.4.3 Adjusting the Angle (Delta control
Panel)
The two-piece Delta control panel can be mounted to
allow angle adjustment of the control panel.
After loosening the set screw below the black cover
❒
by approximately one turn, the angle of the control
panel can be changed.
After adjustment, firmly retighten the screw.
❒
12/2009
Options
Page 127