Control Panel Holder; Control Panel Holder, Swing-Away In Parallel - Otto Bock ParaGolfer Instructions For Use Manual

Fig. 26 Golf bag holder attached
The golf bag is placed on the two supports and fixed with
the straps. After loosening the clamping lever, the front sup-
port can be adapted to the length of the golf bag.
INFORMATION
The golf bag holder can be mounted and the right and left
side of the ParaGolfer. The respective matching mounting
bracket set is required for this purpose.
ParaGolfer
7.2

Control panel holder

WARNING
Risk of injury due to uncontrolled driving characteris-
tics. If the control panel is not fully inserted, the driving be-
haviour of the wheelchair may get out of control. Therefore
make sure when inserting the control panel to push the
holding device (the spring plate) into the receiver up to the
stop.

7.2.1 Control panel holder, swing-away in parallel

The manufacturer offers the option of equipping the power
wheelchair with a removable control panel mounted on a
swing-away control panel holder. This control panel holder
makes it possible to drive the power wheelchair under a ta-
ble or closer to an object.
The control panel holder can be rotated up to the armrest.
1. Apply slight pressure to push the control panel holder to
the side.
 The pivot element is unlocked.
2. Swing the control panel holder away to the side.
The pivot element locks in place again when
INFORMATION
the holder is rotated back to the original position.
Accessories
Ottobock | 59