Headrest; Power Seat Functions - Otto Bock C1000 DS Instructions For Use Manual

Use
29
30
31

8.10.5 Headrest

The head support or head/neckrest stabilises and guides the user's head. It has been mounted to the mounting kit
for head/neckrests by qualified personnel.
Detailed information regarding use, maintenance and repair can be found in the included instructions for use.

8.11 Power seat functions

The power wheelchair can be equipped with a range of different optional power seat functions.
42
Folding down the back support (reducing the
transport size)
1) Pull the release lever up (see fig. 29, item 1).
2) Fold the back support forward or back (see fig. 29,
item 2).
3) Let go of the release lever.
Remove the headrest
Two persons are required to remove the headrest.
1) 1st person: Find the release points on the Recaro®
seat below the cover and push on them both at the
same time.
2) 2nd person: Pull the headrest up and remove.
Removing the Recaro® seat from the mobility base
1) Loosen the left and right locking bolts on the seat
frame. To do this, pull the release strap under the
seat bottom forward and hold it (see fig. 31, item 1).
2) To release the rear seat clip from the bracket, tip
and push the seat back slightly.
3) Remove the Recaro® seat.
Attaching the Recaro® seat to the mobility base
1) Set the back edge of the Recaro® seat onto the end
of the seat frame.
2) Push the seat forward until the rear seat clip pro­
trudes into the bracket.
CAUTION! Risk of injury if the locking bolts are
not engaged. When mounting the Recaro seat,
the seat adapter must be securely attached to
the retainer bushings.
3) Tip the seat forward until the locking bolts engage
with the seat frame (see fig. 31, item 2).
CAUTION! Risk of injury if the locking bolts are
not engaged. Visually inspect and shake the
seat to ensure it is securely locked. The locking
bolts have to snap into place up to the key ring.
C1000 DS