Power Seat Functions; Safety Instructions - Otto Bock Skippi Instructions For Use Manual

Use
CAUTION
Medical risks
Injuries, pressure sores due to application errors
► Regular measures for pressure redistribution and skin examinations are required. Should skin irritation and/or
skin reddening occur, consult the qualified personnel who adapted and adjusted the product. Do not continue
using the product without consultation.
20
Cleaning the positioning belt (lap belt)
INFORMATION
Observe the washing recommendations on the product and the information in the corresponding instructions for
use provided for the product.
Straps with metal closures may not be washed in the washing machine as the penetration of water could
•
cause corrosion and subsequent malfunctions.
• Clean the belt straps by gently dabbing them with warm soapy water (with some disinfectant) or carefully wipe
with a dry, clean, absorbent cloth.
Additional cleaning instructions
• Allow the belts to air dry. Ensure that the belts and pads are completely dry before installation.
• Do not expose the belts to direct heat (e.g. sunshine, stove or radiator).
• Do not iron or bleach the belts.

7.13 Power seat functions

The power wheelchair can be equipped with a range of different optional power seat functions.
For more information on the specific equipment of this power wheelchair, contact the qualified personnel.

7.13.1 Safety instructions

WARNING
Driving with power seat functions
Falling, tipping over due to driving with unallowable seat settings
► Only drive in road traffic and on inclines and downgrades with the seat tilt and seat height adjustments
lowered and with a vertical backrest. Always use a belt system.
► Slightly tilt the seat to the rear when driving down obstacles in a forward direction (e.g. curbs) and reduce the
speed.
► Drive with the seat raised or with the seat tilt/back angle adjustment activated only for short distances at
home. Always use the speed level 1 for this. Note that the field of vision is limited when driving. Always use a
belt system.
► Use the seat height adjustment and the seat tilt only on firm, level ground.
► To avoid uncontrolled driving movements, ensure that the control unit is always in "Power seat functions"
mode before using the power seat functions.
► To avoid hazardous situations, note the correct deflection direction of the joystick (see page 36).
32
Applying the lap belt
Prerequisite: Note the positioning instructions in
>
the previous section.
1) Push the 2 halves together until the buckle engages
with an audible click.
WARNING! The lap belt has to fit closely but
not too tightly so the user is not injured. It
should be possible to slide two fingers com­
fortably between the strap and thigh.
2) Pull to check that it is secure.
Opening the lap belt
1) Press the release button.
2) Open the belt buckle and lay the belt to the side.
Skippi