Lighting; Quad Lighting - Otto Bock Skippi Instructions For Use Manual

Use
29
Swing-away control panel holder
The control panel holder makes it possible to drive the power wheelchair under a table or closer to an object.
The control panel holder can be rotated up to the armrest.
30
31

7.16.2 Lighting

Information on replacing broken lamps: see page 52.

7.16.2.1 Quad lighting

The power wheelchair can be equipped with a lighting set (quad lighting).
The warning flashers, the right and left direction indicators and the light are operated via the supplied lighting
push-button module.
The installed lighting permits driving in road traffic during hours of darkness and is only approved for use on motor­
ised wheelchairs.
40
Pulling off the control panel holder
1) Grasp the control panel holder on the front.
2) Pull the control panel holder off to the front.
Installing the control panel holder
1) Insert the control panel holder into the rail.
2) Slide the control panel holder to the rear.
Swinging away the control panel holder
1) Apply some pressure to push the control panel
holder to the side.
→ The pivot element is released.
2) Swing the control panel holder to the side around
the pivot points (see fig. 30, item 1).
INFORMATION: The pivot element locks in
place again when the holder is rotated back to
the original position.
Removing/installing the control panel
1) Removing: Pull the control panel up and off the ball
head (see fig. 31, item 1).
2) Installing: Set the control panel onto the ball head
and push it down.
Skippi