Table of Contents
Advertisement
11.2 Information on re-use
CAUTION
Used seat padding
Functional and/or hygienic risks due to re-use
► Replace the seat padding if the wheelchair is to be re-used.
The product is suitable for re-use.
Similar to second-hand machines or vehicles, products that are being re-used are subject to increased strain. Fea
tures and performance must not change in a way that could impair the safety of users or third parties during the
period of use.
The relevant product must be thoroughly cleaned and disinfected before re-use. Then have the product inspected
by qualified personnel with respect to its condition, wear and tear, and damage. Worn and damaged parts as well
as components that do not fit or are unsuitable for the user must be replaced.
Detailed information on replacing components as well as information on the required tools can be found in the ser
vice manual.
12 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
12.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
12.2 Warranty
Further information on the warranty terms and conditions is available from the qualified personnel that adapted this
product or the manufacturer's service department.
12.3 Lifetime
Expected lifetime: 4 years
The design, manufacturing and requirements for the intended use of the product are based on the expected life
time. These also include the requirements for maintenance, ensuring effectiveness and the safety of the product.
Failure to observe the manufacturer's specifications and service intervals and using the product beyond the spe
cified expected lifetime leads to increased residual risk.
13 Technical data
INFORMATION
► Much of the technical data below is given in mm. Please note that product settings – unless otherwise spe
cified – cannot be adjusted in the mm range but only in increments of approx. 0.5 cm or 1 cm.
► Note that the values achieved during adjustment may deviate from the values specified below. The deviation
can be ±10 mm and ±2°.
INFORMATION
► Some of the measurements indicated below are values that were theoretically determined.
► Note that not all adjustment possibilities can be used with all product versions. Furthermore, the adjustment
combinations are limited by the compact frame geometry.
► Technical changes and tolerances are reserved by the manufacturer.
General information
Start Multi
Max. load [kg]
1)
Weight [kg]
(for seat width 380 – 480 mm)
2)
Seat width [mm]
Start Multi
Variant with 12" drive wheels
40.5 – 43.5
Variant with 24" drive wheels
136
42 – 45
380 – 480
Legal information
51
Advertisement
Table of Contents
