Legal information
All components of the product must be disposed of properly in accordance with the respective national environ
mental regulations.
10 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
10.2 Warranty
Further information on the warranty terms and conditions can be obtained from the qualified personnel that has fit
ted this product or the manufacturer's service (see inside back cover for addresses).
10.3 Service life
Expected service life: 4 years
The design, manufacturing and requirements for the intended use of the product are based on the expected ser
vice life. These also include the requirements for maintenance, ensuring effectiveness and the safety of the
product.
11 Technical data
INFORMATION
► Much of the technical data below is given in mm. Please note that product settings – unless otherwise spe
cified – cannot be adjusted in the mm range but only in increments of approx. 0.5 cm or 1 cm.
► Note that the values achieved during adjustment may deviate from the values specified below. The deviation
can be ±10 mm and ±2°.
INFORMATION
► Some of the measurements indicated below are values that were theoretically determined.
► Note that not all adjustment possibilities can be used with all product versions. Furthermore, the adjustment
combinations are limited by the compact frame geometry.
► Technical changes and tolerances are reserved by the manufacturer.
General information
Max. load [kg]
Max. load with use in a vehicle for transport
ing persons with reduced mobility [kg]
Transport
weights
(for
1)
430 mm) [kg]
Overall length (with leg support) [mm]
Overall width [mm]
2)
Seat width [mm]
Seat height [mm]
Max. overall height [mm]
Caster wheel size ["]
Ground clearance [mm]
Min. tyre pressure [bar]
Permissible tyre type – drive wheels
Permissible tyre type – caster wheels
46
Start
M4 XXL: 160; M6 Junior: 90
M6 Junior: 75
seat
width
of
Frame: from approx. 9.5
Leg support: approx. 1.4
24" drive wheel (pair): approx. 3.5
See table below
See table below
See table below
See table below
<1,200 (complies with recommendations of DIN EN 12183)
5 to 8
>30 (complies with recommendations of DIN EN 12183)
3)
6
PU tyres, pneumatic tyres
PU tyres, pneumatic tyres, solid rubber
1,300
Start M4 XXL, Start M6 Junior