Black Box Advanced Console Server User Manual page 186

Network Menu & Forms
5. Under Ethernet Port, complete or edit the following fields, as necessary.
6. Under "DNS Service" specify or change the following information, if
7. If you are done go to step 9. If you are enabling "Bonding" continue to
8. To activate Bonding place a checkmark in the "Enabled" field.
9. Click "apply changes."
156
The console banner appears on the console upon logging into and exiting
from a port as a way to verify or identify the particular port connection
a. Enter the IP address of the CS in the "Primary IP" field.
b. Enter the netmask in the "Network Mask" field.
c. If the CS has a second Ethernet card in a PCMCIA slot, enter the CS's
second IP address in the "Secondary IP" field.
d. Specify the network mask of the secondary IP in the "Secondary
Network Mask" field.
e. Specify the desired maximum transmission unit in the "Maximum
Transmission Unit" field.
desired.
a. Enter the address of the domain name server in the "Primary DNS
Server" field.
b. If there is a backup DNS server, enter the address of the secondary
DNS in the "Primary DNS Server" field
c. Enter the domain in the "Domain Name" field.
d. Enter the IP address of the gateway in the "Gateway IP" field.
step 8.
"Miimon" and "Updelay" fields appear.
a. Enter a positive integer in the "Miimon" field. This value represents
the interval in which the active interface is checked to see if it is still
communicating, measured in milliseconds.
b. Enter a positive integer in the "Updelay" field. This value represents
the time that the system will wait to make the primary interface active
after it has been detected as up, measured in milliseconds.