910.07 Data Communication Error; Rip Card Assembly Communication Failure - Lexmark X95x Series Service Manual

7558-xxx
Step Action and questions
Upgrade the firmware. Contact your next level of
29
support for the correct firmware level to use.
Restart the printer to operating mode.
Does the 900.xx error reoccur?
Replace the faulty ISP option. Restart the device.
30
Does the 900.xx error reoccur?
Contact your next level of support. You will need the following information for them:
31
• Exact 900.xx error digits and complete error message
• Printed menu settings page
• Printed network settings page
• Device error log
• A sample print file If the error appears to be isolated to a single file
• File/Application used If the error is related to specific print file
• Device Operating System
• Driver used (PCL/PS)
• Frequency of the occurrence of the error
910.02–910.07 Data communication error
Step Action and questions
Upgrade the firmware.
1
Does the problem persist?
POR the machine.
2
Does the error continue?

939.00 RIP card assembly communication failure

Step Action and questions
Perform a POR.
1
Does the error occur when the
power is turned off/on?
Turn the printer off for 60
2
seconds.
Does the error occur when the
power is turned off/on again?
Check the RIP PCBA for
3
connection.
Is the above sensor connected
properly?
Service Manual
2-266
Go to step 30.
Go to step 31.
Yes
Go to step 2.
Replace the upper printer engine
PCBA.
Go to
"Upper printer engine
PCBA removal" on page 4-189.
Yes
Go to step 2.
Go to step 3.
Replace the RIP PCBA.
Go to
"RIP PCBA removal" on
page 4-153.
Go to step 4.
Yes No
Go to step 26.
Go to step 26.
No
Problem resolved
Problem resolved
No
Perform several print tests.
If the problem remains, then go to
step 2.
Problem solved.
Replace the connection.
Previous
Next
Go Back