Bridge Unit Drive Motor Assembly Removal - Lexmark W850n Manual

Bridge unit drive motor assembly removal

1.
Remove the bridge unit rear cover. See
2.
Remove the bridge unit drive belt. See
page 4-8.
3.
Disconnect the connector from the bridge unit drive motor (A).
4.
Release the harness from the clamp.
5.
Open the bridge unit top cover assembly.
6.
Remove the two screws securing the cover (B) from the bridge unit assembly (C).
7.
Remove the cover (B).
8.
Remove the two screws securing the bridge unit drive motor (A) to the bridge unit assembly (C).
9.
Remove the bridge unit drive motor (A).
"Bridge unit rear cover removal" on page
"Bridge unit drive belt and bridge unit drive pulley removal" on
A
Connector
Rear
Clamp
C
A
B
4024-110
4-6.
4-13
Repair information