Media Eject Clutch Assembly Removal - Lexmark X940e Service Manual

7510-XXX

Media eject clutch assembly removal

1. Remove the rear upper cover. See
2. Disconnect the connector from the sensor (media eject shaft HP) (A).
3. Release the harness from the clamp.
4. Disconnect the connector from the media eject clutch (B).
5. Release the harness from the clamp.
6. Release the hook securing the media eject clutch actuator (C) to the media eject clutch (B).
7. Remove the screw securing the spring clamp (D) to the finisher.
8. Remove the spring clamp (D).
9. Remove the media eject clutch actuator (C).
10. Remove the media eject clutch assembly (B).
Installation note: Make sure the hook on the media eject clutch assembly is placed in the notch of the
bracket.
4-76
MFP Finisher Service Manual
"Rear upper cover removal" on page
A
Connector
B
Notch
B
4-23.
Clamp
D
Connector
C