NEC Univerge SV8100 Features And Specifications Manual page 612

Issue 13.0
Program
Program Name
Number
20-13-24 Class of Service Options
(Supplementary Service) –
Privacy Release by Pressing
Line Key
20-17-01 Operator Extension – Operator's
Extension Number
21-01-03 System Options for Outgoing
Calls – Trunk Interdigit Time
(External)
21-01-18 System Options for Outgoing
Calls – Reset Dial After Failure of
Trunk Access
Operation
For operation instructions, refer to the user guide for the appropriate telephone.
2 - 578
Description/Comments
Set to On (1) for DTPlusWare.
Turn Off or On an extension user
ability to press a line key to barge
into an outside call. Barge-In must
be enabled if this option is used.
DTPlusWare client cannot be set
as operator. Designate an
extension operator. This setting
determines which phone will show
the message notification for
outside caller messages.
Set to 30 seconds for analog
trunks only. The system waits for
this time to expire before placing
the call in a talk state (Call Timer
starts after time expires. Voice
Over and Barge-In are not allowed
until after time expires).
Set to Enable (1) for DTPlusWare.
Enable/Disable an extension user
ability to continue to dial codes or
extensions after receiving Trunk
Busy. This must be Enabled for
this feature to work.
UNIVERGE SV8100
Assigned Data
1
0 = Off
1 = On

(default = 0 for
COS 1~15)
Up to eight digits
(default = ext. 101)
0~64800 (seconds)
(default = 5)

0 = Disable
1 = Enable
(default = 1)

DTPlusWare
Level
2 3
