NEC Univerge SV8100 Features And Specifications Manual page 393

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100
Under certain conditions, HOLD and TRANSFER have the same behavior. To prevent an
unwanted transfer after placing a call on hold and calling another user, the Line Key for the
call on hold must be pressed to retrieve the call from hold, otherwise the call is transferred
when the Cordless Terminal is placed in idle.
term
D
Cordless telephones do not support the Caller ID List feature.
The DTL-8R-1 DECT Cordless – only supports connection with DT300 terminals.
DTH-4R-1/2 Cordless – only supports connection with Series i terminals (DTH/DTR).
DTR-4R-1/2 Cordless – only supports connection with Series i terminals (DTH/DTR).
NEC recommends ITL-8R-1 Cordless IP DECT Terminals be assigned to their own VLAN.
Restrictions
Manual registration mode is not supported for ITL-8R- DECT IP Cordless phones.
Authentication Password is not supported for ITL-8R- DECT IP Cordless phones.
Multiple SIP server registration is not supported for ITL-8R- DECT IP Cordless phones.
Network Address Translation (NAT) transversal mode is not supported for ITL-8R- DECT IP
Cordless phones.
Back Ground Music (BGM) is not supported for ITL-8R- DECT IP Cordless phones.
Cordless terminals cannot receive voice announcements when idle.
The ITL-8R-1 Cordless IP DECT Terminal can only be powered using a POE hub/switch or
POE injector.
The ITL-8R-1 DECT IP Cordless – cannot be connected with DT300 or DT700 terminals.
Voice announce is not supported for ITL-8R-1 terminals. If the SV8100 is set to 0 (Voice) in
Program 20-02-12 each ITL-8R-1 Cordless IP DECT Terminal must be set to signal only
using the dial access code 723. Failure to set the ITL-8R-1 terminal ring either with
Program 20-02-12 or dial access code allows users who call that phone to hear
conversations without the called party's knowledge.
The ITL-8R-1 Cordless IP DECT Terminal only supports port side VLANs.
The ITL-8R-1 Cordless IP DECT Terminal only supports G.711.
Default Setting
None
Cordless DECT Terminals
Issue 13.0
2 - 359

Advertisement

Table of Contents
loading

Table of Contents