NEC Univerge SV8100 Features And Specifications Manual page 315

UNIVERGE SV8100
Program
Program Name
Number
11-12-14 Service Code Setup (for Service
Access) – Trunk Group Access
14-01-01 Basic Trunk Data Setup – Trunk
Name
14-01-02 Basic Trunk Data Setup –
Transmit Level
14-01-03 Basic Trunk Data Setup –
Receive Level
14-01-07 Basic Trunk Data Setup –
Outgoing Calls
14-01-10 Basic Trunk Data Setup – DTMF
Tones for Outgoing Calls
14-02-05 Analog Trunk Data Setup – Dial
Tone Detection for Manually
Accessed Trunks
14-02-11 Analog Trunk Data Setup – Next
Trunk in Rotary if No Dial Tone
14-02-14 Analog Trunk Data Setup – Loop
Start/Ground Start
Central Office Calls, Placing
Description/Comments
Define the service code which
should be used by an extension
user to select outgoing Trunk
Group.
Set the names for trunks. The
trunk name displays on a multiline
terminal for incoming and outgoing
calls.
Customize the transmit and
receive levels of the CODEC Gain
Types for each trunk.
Customize the transmit and
receive levels of the CODEC Gain
Types for each trunk.
Allow or Deny outgoing calls on
the trunk you are programming.
For each trunk, Enable/Disable the
ability to hear the DTMF of the
digits dialed when placing the
outgoing call.
Enable/Disable dial tone detection
for directly accessed trunks. If
disabled, the system outdials on
the trunks without monitoring for
dial tone.
Enable/Disable the system ability
to skip over a trunk if dial tone is
not detected. This option pertains
to calls placed using Call
Appearance (CAP) Keys, Speed
Dial, Automatic Route Selection
(ARS), Last Number Redial or
Save Number dialed. It does not
pertain to line key or Direct Trunk
Access calls.
Select Loop start or Ground start
for the trunk.
Assigned Data
1
MLT, SLT
(default = 704)
Up to 12 Characters
Line 001
Line 002
Line 003
:
Line 200
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
0 = Deny (No)
1 = Allow (Yes)
(default = 1)
0 = Disable
1 = Enable
(default = 0)
0 = Dial Tone
Detection Not Used
1 = Dial Tone
Detection Used
(default = 0)
0 = Disable
1 = Enable
(default = 0)
0 = Loop Start (Loop)
1 = Ground Start
(Ground)
(default = 0)
Issue 13.0
Level
2 3









2 - 281