NEC Univerge SV8100 Features And Specifications Manual page 686

Issue 13.0
Related Features
Drop Key
PBX Compatibility
VM8000 InMail
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-12-42 Service Code Setup (for Service
Access) – Flash on Trunk Lines
14-02-03 Analog Trunk Data Setup – Flash
Type
14-02-04 Analog Trunk Data Setup –
Hooking Type
14-04-01 Behind PBX Setup
15-02-05 Multiline Telephone Basic Data
Setup – Transfer Key Operation
Mode
2 - 652
Description/Comments
Customize the Service Codes for
flash on trunk lines.
Make sure this item is set for open
loop Flash.
For each trunk, select Timed Flash
or open loop Disconnect.
For each trunk, indicate if the trunk
is installed behind a PBX.
For the Cordless Lite/Cordless Lite
II telephone user to use the flash
function, this option must be set to
2. This changes the Transfer key
to a Flash key.
UNIVERGE SV8100
Assigned Data
1
SLT
#
(default = 3)
0 = Open Loop Flash
1 = Ground
(default = 0)
0 = Timed Flash
(Hooking)
1 = Disconnect (Cut)
(default = 0)
0 = Stand Alone
(Trunk)
1 = Behind PBX (PBX)
2 = Not Used
3 = CTX assume 9
(default = 0)
0 = Transfer
1 = Call back
2 = Hook
(default = 0)
Level
2 3





Flash