NEC Univerge SV8100 Features And Specifications Manual page 169

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100
Program
Program Name
Number
26-02-01
Dial Analysis Table for ARS/LCR
– Dial
26-02-02
Dial Analysis Table for ARS –
ARS Service Type
Automatic Route Selection
Description/Comments
Enter the digits (16 digits
#
maximum: 1~9, 0 
, @; 800
separate entries) for the Dial
Analysis Table which is analyzed
by ARS/LCR. This table is
checked after any programmed
F-Route operations have
completed. The system then refers
to Program 26-02-02 and Program
26-02-03 to determine the routing
for the call. To enter a wild card/
don't care digit, press Line Key 1
to enter an @ symbol. It is
important to remember that the
system checks the table numbers
in numerical order. This means
that entries for specific numbers
should be entered first (such as
your local area codes), then enter
the items containing wild card
digits. If the system sees an entry
of 2@@, any table entries which
follow are ignored.
For example, if 268, 269, and 270
are local exchanges, these would
be the first three table entries
which route according to the
settings made in Program
26-02-02 and Program 26-02-03
for each of the table entries. If the
next entry is 2@@, the system
checks no further in this program
and routes all other 2xx numbers
according to the entries made in
Program 26-02-02 and Program
26-02-03 for this table entry.
For each Dial Analysis Table
(1~800), select 0 for no ARS, 1 for
Service Type 1 – Route to Trunk
Group Number to have the
number route to a trunk group
[Refer to Program 26-02-03] or 2
for Service Type 2 – F-Route
Selected to have the dialed
number controlled by the F-Route
table. If Service Type 2 is selected
and F-Route operation is on, the
F-Route table used is determined
by Program 44-04. If F-Route
operation is off, the routing is
determined by Program 44-05.
Assigned Data
1
Dial Digits
(16 digits maximum)
1~9, 0, 
#, or for wild
character (Press line
key 1)
(default not assigned)
0 = No Service (None)
1 = Route to Trunk
Group
2 = Select F-Route
Access
(default = 0)
Issue 13.0
Level
2
3
2 - 135

Advertisement

Table of Contents
loading

Table of Contents