NEC Univerge SV8100 Features And Specifications Manual page 190

Issue 13.0
All Flexible Line keys on a multiline terminal can be assigned as CAP keys in System

Programming.
A conference call involving two outside lines cannot reside on one Call Appearance key.

For Call Appearance (CAP) Keys, trunks must be assigned to trunk group 1 or higher

(Program 14-05-01). Trunk Group 0 means KF (Key Function) mode.
CAP Keys can be programmed from 0001~9999. 0000 assigns the next available CAP

Key.
Trunk Group (

cannot be programmed on a DSS Console as the system does not allow entry of the
additional data required.
If you have both trunk line keys and Call Appearance (CAP) Keys, the line key has priority.

An incoming call rings the trunk line key and when answered, the trunk line keys lights, not
the CAP Key. When you access the trunk for an outgoing call, the Trunk line key lights, not
the Call Appearance (CAP) Key.
With Version 4000 or higher software, CAP keys can only be assigned or used if Program

20-02-23 is set to Original (0).
A system can have only CAP keys or Loops keys.

When SV telephones are installed, CAP key mode must be used. When UX telephones are

installed, Loop key mode must be used.
Default Setting
Disabled
System Availability
Terminals
SV8100 Terminals only
Required Component(s)
None
2 - 156
02), Virtual Extension (

03) and Call Appearance (CAP) Key (

UNIVERGE SV8100
08), codes

Call Appearance (CAP) Keys