Windshield Wiper And Washer Lever - Suzuki Jimny 2022 Manual

Windshield Wiper and Washer
Lever
When the ignition switch is in "ON" position
or the ignition mode is ON, you can use
the wiper/washer lever.
CAUTION
In cold weather, the sprayed washer
fluid on the glass may get frozen and
it may cause poor visibility to a
driver. Use the defroster to warm the
glass and spray the washer fluid.
Refer to "Heating And Air Condition-
ing" in the "OTHER CONTROLS AND
EQUIPMENT" section.
NOTICE
• If you use the wipers with the glass
dried, the glass and the wiper blade
rubbers may be damaged. When
the glass is dry, use the washer
fluid and then use wipers.
• If you operate the wipers with the
wiper blades stuck on the glass,
the wiper blade rubbers may be
damaged or the wipers may be bro-
ken. When the wiper blades are
stuck on the glass, do not operate
the wipers.
(Continued)
NOTICE
(Continued)
• If you use the washer when the
washer fluid cannot be sprayed
enough, the washer pump may be
broken. When the washer fluid can-
not be sprayed enough, turn off the
washer switch.
When the operative wipers suddenly
stop
When the wipers are under heavy load
such as covered by snow and the tem-
perature of the wiper motor becomes high,
the breaker will be activated and the wip-
ers will temporarily stop to protect the
wiper motor from overheating.
If this happens, perform the following oper-
ations:
1) Stop the vehicle in a safe place, and
turn the ignition switch to "ACC" or
"LOCK" position or press the engine
switch to change the ignition mode to
ACC or LOCK (OFF).
2) Move the wiper lever and switch to
"OFF" position.
3) Remove obstacles such as snow on the
wipers.
4) After a while, when the temperature of
the wiper motor becomes low enough,
the breaker will be reset automatically
and you can use the wipers.
BEFORE DRIVING
If you cannot use the wipers after a while,
there may be another problem. Ask an
authorized SUZUKI dealer or a qualified
workshop to have the wipers inspected.
Windshield Wipers
68PM00237
You can operate the windshield wipers by
moving the lever (1) upward or downward.
Temporary operation only
MIST
while the lever is up
OFF Off
INT Intermittent operation
LO Low speed operation
HI High speed operation
80TS - 01E
3-38